Harley Davidson Grip Installation

VIDEO-In this DIY video we show you how to easily install new basic handgrips on your Harley Davidson motorcycle.

Harley davidson grip installation. Free Video By Bikers for Bikers. Untitled Document This is your guide for how to replace Harley-Davidson handlebar grips. Reassemble the right side hand grip switch housing and front master cylinder.

Improper installation of this kit could result in death or serious injury. Avon grip install - 2010 flhx. Insert the plug back through the opening in the grip and insert the terminal pins into the sockets at the end of the twist grip sensor engaging the two legs of the plug into the throttle grip sensor openings.

Bob and Mark take their time and get the stock competes back in place and install a new grip. WARNING Before starting engine be sure throttle control will snap back to idle position when released. This video covers Harley clutch lever housing and grip installation.

Carefully rotate the pherrules so they come out of the throttle sleeve then you can slide the old grip off. I will leave a link below for the Avon grips that I used. Videos you watch may be added to the TVs watch history and influence TV recommendations.

Route the heated hand grip wires over to the Electrical Connection Harness. Loosen the clamp and under it you will phind the ends of the throttle idle cables. Less bulky than the Harley version Very easy to hook up and they work great.

Rider and passenger safety depend upon the correct installation of this kit. Rider and passenger safety depend upon the correct installation of this kit. Dont forget to plug the twist grip sensor back in if you have not already.